WAD 100B removes bathroom condensation by warming fresh external air.
The Warm Fresh Air Dehumidifier for Bathrooms is an automated bathroom fan, with dual actions of both intake and extraction of air, with the benefit of warming the fresh external air as it is drawn into the building, when the temperature is below 14°C. This unique feature is available using a single vent to the outside, that will fit on to an existing 100mm (4”) bathroom fan vent.
The unit operates for your maximum benefit and air condition with internal humidity control, an external temperature sensor, light or switch extract, and bluetooth app control. This unit includes filters which helps keep out various pollutants, which should be changed yearly.
The warmed dehumidified air provides a simple and effective solution to keeping your home dry, the mild warming of the air provides for a refreshing method of keeping your home dryer by displacing wet air with dry air. This unit works best when used as part of a cross-flow ventilation system with other Vapourflow units.
Vapour Flow Warm Air Dehumidifier Bathroom Fan Features and Benefits
For best results use the WAD as part of a cross-flow ventilation system with other Vapourflow units
Filtered warm dry fresh air creates a dryer place in your bathroom that extends further in to the property
Extracts air during times of occupancy, expelling excess airbourne moisture when required
Your existing fan in the bathroom can be exchanged as this is a standard 100mm vent connection
This positive pressure system requires no extra ducting to be extended in to the centre of the property as the air naturally expels past the bathroom door and in to the middle of your home.
The 200 watt heater only works when the external temperature is below 14°C and is not required when the fan is in extract mode.
Incorporates the Autostat Humidity Controller which continually monitors ambient humidity and automatically adjusts the control level accordingly
Low energy, low cost fan continuous running at 0 > 20m³/h
Can be fixed in any orientation (wall, ceiling)
Polycarbonate ABS mix with fire retardant housing which provides a robust and high temperature resistant casing.
Produces up to 80m³/h of airflow
Manual override extract option via light/switch live or bluetooth app
Remote Autostat available to provide automatic extract mode
5 year motor guarantee, 2 year product guarantee
The system becomes increasingly effective with the addition of Vapour vents in the bedroom areas.
General Notes on Fan Installations
The fan position should be as far as practical from the main source of air replacement. This is to avoid short-circuiting of the airflow. The fan can be placed on a wall or ceiling. The Warm Air Dehumidifier Bathroom Fan has a 100mm spigot to fit into a circular telescopic wall sleeve. The ducting hole through the wall requires a minimum of a 5 degree downward slope to the outside.
The fan should be located at a high level close to the moisture source. If the room/ dwelling contains a fuel burning device such as a gas boiler with a non-balanced flue, it is essential that there is enough replacement air to prevent fumes being drawn down the flue where the fan is extracting.
And for the Specifier…
The WARM AIR BATHROOM DEHUMIDIFIER fan is supplied with an internal Autostat and heater, and pull cord switch.
VapourFlow products are designed with longevity in mind, for this, they need to be cleaned and maintained on a regular basis.
It is advised that every 6-12 months the following should be done:
- Wipe the chassis and grilles with a damp cloth to remove any detritus
- Hoover the grilles to remove any large dust particles that may have been formed
- Replace any filters on the unit every 12 months (Replacement filter packs available from https://www.vapourflow.com/product/10x-extractor-fan-foam-filters/